Original
By certification 
Application:
Transparent insulation sleeve provides encapsulation,inspect, strain relief, and insulation.Pre-fluxed solder provides controlled soldering process.One piece design, it consists of transparent heat shrinkable sleeve and fluxed solder. Provides insulation and lower the installed cost. Color hot-melt glue on two ends of heat shrinkable tube, connecting wires to component terminals, such as motor tabs, connector pins, and switch terminals,it is very convenience to use the exact wire dimension. Shrink closed-end connectors can replace wire nuts in environments where need to be sealed.
■ Characteristics：
●Shrinkage ratio 2：1
●Waterproof for wiring splices
●Transparent sleeve provides precise inspection
●Easy control soldering process
●Minimum Shrink Temp. 60℃
●Minimum Fully Recover Temp.110℃
●Fully melt temperature of solder: 138℃
■ Technical Data:
| Operating temperature | -55℃~125℃ |
| voltage Resistant | ＞600V |
| Protection type | IP67 |
| Volume Resistivity (Ω cm): | ≥10 15 |
| Dielectric Strength (KV/mm) | ≥25 |
Size:
| Product Code | Ball Color |
Product Dimensions | Copper Cross Section | Qty Solder | |||
|---|---|---|---|---|---|---|---|
| ΦA | L(mm) | B | Min mm2 | Max mm2 | |||
| HP-SST-SGRS-05-01 | Green | 3.6 | 38 | 26 | 0.7 | 2.4 | 1 |
| HP-SST-SGRS-05-02 | Red | 5.0 | 38 | 26 | 2.0 | 4.0 | 1 |
| HP-SST-SGRS-05-03 | Blue | 7.5 | 45 | 30 | 3.5 | 8.0 | 1 |
| HP-SST-SGRS-05-04 | Yellow | 9.4 | 45 | 30 | 7.5 | 12.0 | 1 |
Other sizes are available upon request.
●Item 1: Insulation Sleeve : Heat shrinkable, transparent blue, radiation cross-linked modified polyvinylidene fluoride
●Item 2: Solder Ring with flux
●Item 3: Conical Spring (Square copper wire)
●Item 4: End Closure Ball (tinted glass, color see table)
●Item 5: Sealing insert (Glue rings)
■Color:
Standard color: Green, Red, Blue,Yellow
Other colors are available upon request.
